DFW Summer Open Data Dive: Pitching
June 5, 2023
On Tuesday, May 30th the PBR Texas team hosted the DFW Summer Open at Lake Dallas High SChool. The event featured over 70 players and provided our staff with an in-depth look at some of the area's top prospects.
Earlier this week, we broke down the top measurable data performers from the event with our Stat Story. Now, we will take a further in-depth look at the top pitchers with the help of our tech partnerships, broken down by the categories down below:
FASTBALL
MAX VELOCITY (MPH)
Max Fastball Velocity: This metric calculates the speed of the pitch as it’s released from the pitcher’s hand.
SPIN RATE (AVG.)
Spin Rate: This metric calculates the rate of spin on the baseball as it leaves the pitcher’s hand, measured in revolutions per minute (rpm). Historical data shows that high-spin fastballs lessen the impact of gravity, allowing for more ‘rise’ (or less fall, in other words) as it carries through the zone. Low-spin fastballs typically indicate the pitch has greater horizontal action, often making it tougher to square up, but generally easier to make contact with, leading to more ground balls, while high-spin fastballs show a correlation with swings and misses.
INDUCED VERTICAL BREAK (AVG.)
Induced Vertical Break: Used in short form as "IVB," this metric is most important on fastballs for creating rise and on curveballs for creating depth – it can also have some use when measuring sliders and cutters as well. Sliders tend to be closer to zero inches while cutters are generally between 5 and 15 inches. Usually fastballs and curveballs with large IVB have higher spin efficiencies as well. Sliders generally have very little (closer to zero) IVB and very low spin efficiency. You could also categorize IVB into spin rate as this is part of the “useful movement” you’re looking for. IVB is also a huge part of the vertical approach angle.
HORIZONTAL MOVEMENT (AVG.)
Horizontal Break: Outlined on TrackMan’s own website: “... horizontal movement is measured in inches between where the pitch actually crosses the front of home plate side-wise, and where it would have crossed home plate side-wise if had it traveled in a perfectly straight line from release. A positive number means the break was to the right from the pitcher’s perspective, while a negative number means the break was to the left from the pitcher’s perspective.”